3x4 inch horizontal badge holders

Click on the image for a larger view

3 x 4 Insert / Pin

BH410G01 Badge Holder

Outside dimensions (hxw): 3.0625 x 4.0625

Orientation: Horizontal

Insert: Loads from side or back can be opened

Material: 7.5 mil front and back, acetate

Attach: Simple pin on back of holder (included)

Click on the image for a larger view

3 x 4 Insert / Slot / Holes

BH575SH04 Badge Holder

Outside dimensions (hxw): 3.5 x 4.25

Orientation: Horizontal

Insert: Top loading

Material: 10 mil rigid front, 8 mil back, vinyl, reinforced header strengthens slot.

Attach: Slot can accommodate a bulldog clip such as found on a lanyard or on a short plastic strap. Back is .25 inches higher than front so that slot and holes are above the insert. Alternatively, the holes can be used for an elastic cord or a chain.

Click on the image for a larger view

3 x 4 Insert / Holes

BH553H03 Badge Holder

Outside dimensions (hxw): 3.125 x 4.25

Orientation: Horizontal

Insert: Top loading

Material: 10 mil rigid front, 8 mil back, vinyl

Attach: Holes can accommodate a chain or elastic cord. J hook lanyard can be forced through the small center hole.

Click on the image for a larger view

3 x 4 Insert / Magnetic

BH553M03 Badge Holder

Outside dimensions (hxw): 3.125 x 4.25

Orientation: Horizontal

Insert: Top loading

Material: 10 mil rigid front, 8 mil back, vinyl

Attach: Magnetic bar, placed behind clothes or in pocket, is attracted to the piece of metal on the back of holder. Extra strong magnet has been found to hold very well. Magnet included.

Click on the image for a larger view

3 x 4 Insert / Clip

BH553C01 Vinyl Badge Holder

Outside dimensions (hxw): 3.125 x 4.25

Orientation: Horizontal

Insert: Top loading

Material: 8 mil front, 8 mil back, vinyl

Attach: Bulldog swivel clip, riveted to back of holder, can be attached to pocket, seam of shirt or other location. Clip included

Click on the image for a larger view

3 x 4 Insert / Pin/Clip combo

BH553B01 Vinyl Badge Holder

Outside dimensions (hxw): 3.125 x 4.25

Orientation: Horizontal

Insert: Top loading

Material: 10 mil rigid front, 8 mil back, vinyl

Attach: A combination bulldog swivel clip and safety pin is riveted to the back of the holder. The clip can be attached to pocket, seam of shirt or other location. Optionally the pin can be used to attach the holder to a shirt. Pin/clip combo included

Click on the image for a larger view

3 x 4 Insert / Pin

BH553P01 Vinyl Badge Holder

Outside dimensions (hxw): 3.125 x 4.25

Orientation: Horizontal

Insert: Top loading

Material: 8 mil front and back, vinyl

Attach: Simple pin on back of holder (included)