2.25x3.5 & 2.5x3.5 inch horizontal ID badge holders

Click on the image for a larger view

2.25 x 3.5 Insert / Pin

BH410D01 ID Badge Holder

Outside dimensions (hxw): 2.3125 x 3.5625

Orientation: Horizontal

Insert: Loads from side or back can be opened up

Material: 7.5 mil front and back, acetate (rigid clear plastic)

Attach: Simple pin on back of holder (included)

Click on the image for a larger view

2.25 x 3.5 Insert / Slot

BH471S01 ID Badge Holder

Outside dimensions (hxw): 2.6875 x 3.75

Orientation: Horizontal

Insert: Top loading

Material: 10 mil rigid front, 8 mil back, vinyl

Attach: Slot can accommodate a bulldog clip such as found on a lanyard or on a short plastic strap. Back is .25 inches higher than front so that slot is above a 2.25 inch high insert.

Click on the image for a larger view

2.5 x 3.5 Insert / Holes

BH471H01 ID Badge Holder

Outside dimensions (hxw): 2.6875 x 3.75

Orientation: Horizontal

insert: Top loading

Material: 10 mil rigid front, 8 mil back, vinyl

Attach: Holes can accommodate a chain or elastic cord (not included). J hook lanyard can be forced through the small center hole.

Click on the image for a larger view

2.5 x 3.5 Insert / Magnetic

BH471M01 Vinyl ID Badge Holder

Outside dimensions (hxw): 2.6875 x 3.75

Orientation: Horizontal

Insert: Top loading

Material: 10 mil rigid front, 8 mil back, vinyl

Attach: Magnetic bar, placed behind clothes or in pocket, is attracted to the piece of metal on the back of holder. Extra strong magnet has been found to hold very well. Magnet included.

Click on the image for a larger view

2.5 x 3.5 Insert / Clip

BH471C01 Vinyl ID Badge Holder

Outside dimensions (hxw): 2.6875 x 3.75

Orientation: Horizontal

Insert: Top loading

Material: 10 mil rigid front, 8 mil back, vinyl

Attach: Bulldog swivel clip, riveted to back of holder, can be attached to pocket, seam of shirt or other location. Clip included

Click on the image for a larger view

2.5 x 3.5 Insert / Pin/Clip combo

BH471B01 Vinyl ID Badge Holder

Outside dimensions (hxw): 2.6875 x 3.75

Orientation: Horizontal

Insert: Top loading

Material: 10 mil rigid front, 8 mil back, vinyl

Attach: A combination bulldog swivel clip and safety pin is riveted to the back of the holder. The clip can be attached to pocket, seam of shirt or other location. Optionally the pin can be used to attach the holder to a shirt. Pin/clip combo included